Search found 3507 matches

by vad
19 Aug 2019 00:55
Forum: Beginner's questions about the Crystal Hardware
Topic: Hyperterminal setting
Replies: 1
Views: 16

Re: Hyperterminal setting

9600, 8N1, no control
by vad
15 Aug 2019 05:36
Forum: MAIN
Topic: No Voice Path on ISDN Trunk
Replies: 2
Views: 73

Re: No Voice Path on ISDN Trunk

Why you talk about IP/domain/compression - and PRI T2? PRI (E1) - TDM connection, without VoIP compression.
At the beginning - shjw "t3" trace.
by vad
15 Aug 2019 05:33
Forum: Boards
Topic: New CPU8 - LAN / Serial Connection
Replies: 11
Views: 356

Re: New CPU8 - LAN / Serial Connection

I think problem not with CPU-8 but with W10 (not working RS-232). Easy to find - start terminal program, connect Rx to TX (more easy with DB-9 connector). Type something. If you see what you type - V24 works.
by vad
09 Aug 2019 07:42
Forum: MAIN
Topic: Remote ACT behind NAT
Replies: 2
Views: 116

Re: Remote ACT behind NAT

If NAT cannot be used - make VPN between sites.
by vad
09 Aug 2019 02:45
Forum: Configuration
Topic: DID via SIP goes to Reception
Replies: 3
Views: 123

Re: DID via SIP goes to Reception

Read in system doc about "DID with more than 4 digits" (installation number etc.) Another (not sure) - you can "cut" the number. F.e. you have 086104XXXX Create in dialing plan (public, private, restricted) - Loop Back Current 086104 086104 After this number 0861042405 will be transformed to 2405 an...
by vad
08 Aug 2019 04:06
Forum: Configuration
Topic: DID via SIP goes to Reception
Replies: 3
Views: 123

Re: DID via SIP goes to Reception

Make SIP trace - may be you receive Calling number not 61042405 but (f.e.) 2405, 061042405....
And create Subscribers in Private plan too.
by vad
05 Aug 2019 03:53
Forum: MAIN
Topic: SiP Trunk DID
Replies: 3
Views: 230

Re: SiP Trunk DID

Why you post this question in ALU PABX forum? Only for signature with link?
by vad
24 Jul 2019 01:10
Forum: ON SITE TROUBLES
Topic: Illegal hardware key
Replies: 3
Views: 181

Re: Illegal hardware key

When you replace CPU - you need new OPS files with CPU-Id for new CPU.

Or your seller give you wrong OPS files, or
You not install new OPS files.
by vad
24 Jul 2019 01:05
Forum: Beginner's questions about the (4400 / Enterprise) PHONE APPLICATION or OPERATING SYSTEM
Topic: Onnet calls failing
Replies: 5
Views: 226

Re: Onnet calls failing

Ok - in previous you use ABC-F connection.
Now you use usual H323 TG (Q931 signal variant - ISDN all countries) and call via Speed dial (not used network|routing prefixes from previous ABC-F connection)?
by vad
23 Jul 2019 02:04
Forum: Beginner's questions about the (4400 / Enterprise) PHONE APPLICATION or OPERATING SYSTEM
Topic: Onnet calls failing
Replies: 5
Views: 226

Re: Onnet calls failing

Can you give us some information - PBX type, previous connection (ABC-F, H323, SIP), some trace (t3, SIP)...?

Go to advanced search