Alcatel Unleashed

Hello Somebody know what means this entries in swlog? INTERFACE info eniLinkStatusChange:5991 Successfully processed the link status change to CMM fo MON APR 16 10:19:17 2018 INTERFACE info [Count.]r lport - 0 and linkstatus - 2 MON APR 16 10:19:17 2018 INTERFACE info eniSendLinkStatusMsg2falcaddr:1...

ok, I guess is the best too, I doubted it because the same version work right in other sw.

Thanks

hello Somebody know why in some devices if active lanpower with "lanpower start 1" or desactive "lanpower stop 1" AOS don´t display the advice that say if the daughter module is on or off. Even if the module is on, you can't see the line "lanpower start 1" in the config...

Hi, I'm do this right now, uploading the img files by Zmodem, my doubt is, is necessary uploading all the img files?

which files are needed to boot? and after will upload the Kadvrout.img by ftp for example.

It's possible?

Regards

uh

Hi Jorge Here stuck with this ... :lol: The version is 8.1.0b5248 ... (I know, very old) And no limits like, Port limits, recording etc. when the conference is create the options are by default, only remove the option tones when in or out, and check the option "modo ponencia" the participa...

Hi All, I need your help for some tips on the following problem We created a Schedule Conference with specifics access codes for leader and participants, this conference is daily at 7 am; all the conference option remain default, only check “all participants start in mute” and “not allow unmute for ...

Is it possible restart the access codes?

my customer requires to use a specific code, and the system does not allow it, maybe was used previously.

Thanks

I have a old 4324 with AOS Version 5.0.4.10, the last years this equipment has been used for test (a lot of configurations), and now does strange things (Captive Portal stop working, the equipment no respond), I reload the switch and work again. I applied the command "write erase all", but...

Sweet! ... thanks a lot

uh

Hello all, In a stack of 6 x OS6850-P24, in dshell mode apply the command bShell , and after g hold display this: Certified: [Kernel]->bShell Broadcom Command Monitor (BCM) service started. BCM.0> g hold g hold HOLD.ge0[0xe700014]=0: <COUNT=0> HOLD.ge1[0xe701014]=0: <COUNT=0> HOLD.ge2[0xe702014]=0xf...