I have 9 crystals in my OXE system and we are running R9.1. I have a PRI with another PBX (Coral) with 300 channels. recently there is an issue where the users from one particular crystal cannot access the trunk where as users from all the other crystals can make the calls. Also, only outgoing calls to Coral PBX from OXE are affected and the incoming calls to OXE are fine. The issue is with 700 Analog extenions ( Crystal No 5) only. I replaced the nprae board, chekced the access code status, Public Network COS. All are looking fine. Please help me with this.
Top
DOD not working in only 1 crystal
Re: DOD not working in only 1 crystal
how about a t3 that would be a great start
"Be aware ask a stupid question without at least trying to find the answer first you may get a stupid answer....."
Re: DOD not working in only 1 crystal
Sorry for delayed response i was on leave due to ill health. I am posting t3 log in this mail. I was not properly trained by alcatel,, @oldboy , i would appreciate the help if you can help in understanding t3. These are the logs in different dates when the problem is there. I have this issue in OXE from 74xxx to 745xx ( CRYSTAL 5). the destination number i am dialing on CORAL PBX is 86659. The CORAL PBX dialing level starts from 8xxxx. I tested for 2 cases.
Case1: to CORAL PBX, no outgoing call. only incoming if i dial from 740xx to 745xx ( Crystal 5). All the remaining numbers are working fine in the remaining crystals
Case2 : to Siemens PBX from the same number series as in above case, both incoming and outgoing are working
Please have me to solve this.
Case1: to CORAL PBX, no outgoing call. only incoming if i dial from 740xx to 745xx ( Crystal 5). All the remaining numbers are working fine in the remaining crystals
Case2 : to Siemens PBX from the same number series as in above case, both incoming and outgoing are working
Please have me to solve this.
You do not have the required permissions to view the files attached to this post.
Re: DOD not working in only 1 crystal
Show - "config all" command output (for System architecture understanding).