can't get Mediant 8000 card tp-6310-t3 to load

Post Reply
michaelnwr
Member
Posts: 14
Joined: 26 Jun 2013 13:49

can't get Mediant 8000 card tp-6310-t3 to load

Post by michaelnwr » 09 Jul 2015 15:43

I preform the following command to unlock the card after I add it but the card will not load the software and come up.
"unlock /moGW/moBoard#11" (Also when I run this command I don't receive any output saying that it has been unlocked like what the manual says should show)

when I look at the config of the card it says unknown for the software. It does not appear that this is a field that I can modify (I have tried already says it doesn't have a write access)

see below for show hw output for TP boards table

TP Boards Table
================
Slot# | Board Type | Software Version | Temperature 1 |
--------------------------------------------------------
11 | Tp6310Ds3 | unknown | -99 |
12 | Tp6310Ds3 | 5.40A.001.009 | -99 |
13 | Tp6310Ds3 | 5.40A.001.009 | -99 |
14 | Tp6310Ds3 | 5.40A.001.009 | -99 |
17 | Tp6310Ds3 | 5.40A.001.009 | -99 |
DAM8K02-SC1::/#

I have changed the config for the card to unlock the card on boot but adding the following line.

modify /moGW/moBoard#11 UserRequestAdminState(rw,instant,none)=Unlocked(2)

however after a reboot the following shows for the card.

Slots Table
================
Slot# | Board Type | Admin State | Oper State | Severity | Activity |
----------------------------------------------------------------------------
1 | Sc | Unlocked | Enabled | clear | normal |
2 | Sc | Unlocked | Disabled | clear | redundant |
9 | Switch6600 | Unlocked | Disabled | clear | normal |
11 | Tp6310Ds3 | Locked | Disabled | indeterminate | normal |
12 | Tp6310Ds3 | Unlocked | Disabled | major | normal |
13 | Tp6310Ds3 | Unlocked | Disabled | major | normal |
14 | Tp6310Ds3 | Unlocked | Disabled | major | normal |
17 | Tp6310Ds3 | Unlocked | Disabled | major | redundant |
19 | Switch6600 | Unlocked | Disabled | clear | redundant |


and it still says unknown for the software version. Am I missing a step here to get the card to load the software?

Post Reply

Return to “AUDIOCODES”