Hello,
I have a 9700 that will not boot past uboot. Getting the error "bad magic number" on startup and when trying to get to miniboot. Is there a good resource/guide for restoring the file system on the flash? I did see a procedure for USB restore, however I cannot use a USB thumbdrive as those are not allowed at the facility I work in.
So far I've tried TFTP boot with no luck. I do have other 9700's available with working CMM's, I thought of trying to flash-synchro off of one of those but I didn't know if that will work or if there's a better way of restoring the switch.
Any help is appreciated.
Both CMM's stuck at uboot
Re: Both CMM's stuck at uboot
Please post more output.
If you can access miniboot you can try to recover using X/Zmodem see http://www.alcatelunleashed.com/viewtopic.php?t=19531 should be similar for CMM in 9700 otherwise search board here.
If you can access miniboot you can try to recover using X/Zmodem see http://www.alcatelunleashed.com/viewtopic.php?t=19531 should be similar for CMM in 9700 otherwise search board here.
Re: Both CMM's stuck at uboot
I can't get to miniboot.
Re: Both CMM's stuck at uboot
I'm getting the same error. Where can I access the output to post it here, Devnull?
-
- Member
- Posts: 19
- Joined: 26 Jun 2019 12:13
- Location: United Kingdom
- Contact:
Both CMMs stuck at uboot
Yeah it should be about 14.8 volts ... thanks for the tip ... Ill replace the reg and see what happens from there
https://www.nacdd1305.org/