Hello,
I 've some problems with an OmniSwitch 6602-48. When the switch boots, I get the message that there is no certified configuration and the switch goes to Miniboot. How can I put a new certied config on the switch running in Miniboot?
Best regards,
Kai
Crashed Certiefied
Re: Crashed Certiefied
Hi!
Probably you still have the images in the working directory. Please try to boot from the working directory as I described it in the following thread.
viewtopic.php?f=86&t=3178
In case that you are stuck in Miniboot again you have no other choice than transfering the images through zModem over Console connection.
Regards,
Benny
Probably you still have the images in the working directory. Please try to boot from the working directory as I described it in the following thread.
viewtopic.php?f=86&t=3178
In case that you are stuck in Miniboot again you have no other choice than transfering the images through zModem over Console connection.
Regards,
Benny
Regards,
Benny
Benny
Re: Crashed Certiefied
Hi!
How can I load image files to certified folder using zModem?
Or perhaps there is a way to copy files using usb flash?
How can I load image files to certified folder using zModem?
Or perhaps there is a way to copy files using usb flash?
Re: Crashed Certiefied
hi
there is no usb on 6600
If you serach there is a post with upload file with Zmodem
viewtopic.php?f=152&t=6241&p=30384&hilit=zmodem#p30384
but insetad of using setenv type c
after this you are prompted to change some setting (baudrate) etc and change flag value 0x0 to 0x1000
enter : @
so you will reboot to miniboot
follow post from beeny (url I paste) to enter in certified directory
cd "certified"
and start zmodem sysStartZmodem
when file is upload enter
reboot
interrupt boot and type again c
change baudrate to 9600 and flag to 0x0
type @
Regards
Cedric
there is no usb on 6600
If you serach there is a post with upload file with Zmodem
viewtopic.php?f=152&t=6241&p=30384&hilit=zmodem#p30384
but insetad of using setenv type c
after this you are prompted to change some setting (baudrate) etc and change flag value 0x0 to 0x1000
enter : @
so you will reboot to miniboot
follow post from beeny (url I paste) to enter in certified directory
cd "certified"
and start zmodem sysStartZmodem
when file is upload enter
reboot
interrupt boot and type again c
change baudrate to 9600 and flag to 0x0
type @
Regards
Cedric