OmniStack 6224 in debug mode

[AznulHilmi]

Hi,

I am new with this 6200 series so go easy on me... I have 'played' around with 6800 series before, but still that doesn't make me an expert.

I have a problem with my 6224 switch. After is boots, it goes to the debug mode (debug>) :

DEBUG>os fatal error
%OS-F-DEBUG: DEBUG fatal error0 01:05:10

***** FATAL ERROR *****
Reporting Task: STSA.
Software Version: 1.5.0.95 (date 08-Aug-2007 time 11:23:14)
0xb5fec
0x415e30
0x2a4108
0x2a45c4
0x2a84a8
0x2a85b8
0x4117fc
0x3d05d4
0x3d1130
0x3d1a74
0x3d2498
0xabc08

**************************************************
***************** SYSTEM RESET *****************
**************************************************
Boot1 Checksum Test...............................PASS

Boot2 Checksum Test...............................PASS

Flash Image Validation Test.......................PASS

Is there anyone out there that can help me with this? how do i go back to the normal CLI mode. And I have been searching in the internet and can't seem to find the Debug command list for the switch.

Thanks in advance

Aznul Hilmi

[silvio]

Hi,
the error looks like in the attached docu. Try to recover the image like descriped.
regards Silvio

[AznulHilmi]

Thanks Silvio,

That did the trick.