OmniAccess 4304

[phangorn]

Hi,

I got an old OAW-4304
It come with an old 3.2.x firmware

I have upgrade it to 3.4.5.1 and then to 5.0.4.16

the switch successfull reboot.
To have a clean system, I have the bad idee to reset the switch to factory default (via the web interface)...

the switch reboot and now I'm stuck to the initial configuration web interface.
When I conplete it, after reboot I return to initial config....

I' tried to log on serial console but I get no output (my serial cable is OK on an OS6450P-48)

if someone could have an idee to retake control of this wlan switch ..

[silvio]

Hi,
serial adapter for OAW is an other than for omniswitches. You need for OAW the same adapter like for cisco.
If you have completed the initial wizard via web (via default ip 172.16.0.254) than you have created your own ip interface. Why didn't you use this one
regards
Silvio

[phangorn]

The switch doesn't save the wizard config, after reboot I fall to the wizard agains...

I'll try to find a cisco like adapter !

[devnull]

If you have cisco equiptment: blue cable