I managed to make OXE GD board from OXO cpu-1. OXE software 7.1.
But is it possible to make OXE CS from OXO cpu-1?
Oxo cpu into gd board
- tot3nkopf
- Alcatel Unleashed Certified Guru
- Posts: 4058
- Joined: 02 Feb 2006 10:41
- Location: Germany & Romania
- Contact:
Re: Oxo cpu into gd board
Should be (never did it). It is the same board. You need however xmem and hdd.
- pantisimus
- Member
- Posts: 19
- Joined: 05 Feb 2010 18:19
Re: Oxo cpu into gd board
It is the same hardware, but seems bios to be different. It is not possible to change boot device, Network, hdd ... Bios is searching for flash memory or HDD. If Flash is deleted, than software loading starts but soon after, there is a message on Alcatel Installer that booting is stopped. Just like it is not allowed in installer. MAC address of that cpu-1. If you have ideas, please, suggest, I am happy to check.
- tot3nkopf
- Alcatel Unleashed Certified Guru
- Posts: 4058
- Joined: 02 Feb 2006 10:41
- Location: Germany & Romania
- Contact:
Re: Oxo cpu into gd board
Did you tried to put the mex and hdd and then load it like a regular CS?
- pantisimus
- Member
- Posts: 19
- Joined: 05 Feb 2010 18:19
Re: Oxo cpu into gd board
Nooo, just Memory module and HDD, I do not have extra mex. You think it is mandatory?
- tot3nkopf
- Alcatel Unleashed Certified Guru
- Posts: 4058
- Joined: 02 Feb 2006 10:41
- Location: Germany & Romania
- Contact:
Re: Oxo cpu into gd board
Sorry, meant xmem.
- pantisimus
- Member
- Posts: 19
- Joined: 05 Feb 2010 18:19
Re: Oxo cpu into gd board
Yes. yes, I understand you. The CPU-1 board saw the Hard Disk, but failed during installation. At the moment files shoud be transfered from PC to CPU-1 board. On this CPU-1 board, I have memory board and Hard Disk. XMEM is together with Hard Disk. XMEM-1 3EH73049ADAA