Alcatel Unleashed

Good morning to everybody.

I have a client with an OXE in R11.2.2 with cpu 7-2 and IO2N board. I want to make redundancy with another 7-2 CPU and IO2N board. The actis puts CPU 7-2 in position 10 and IO2N in position 11. When I try to do the mastercopy I can not duplicate both cpu's and the cpu of position 10 remains in undefined. When I run the spadmin I do not see the id of the second cpu, although I understand that if that is why I should put the pannic flag to 1 but let me do the redundancy.
Has something similar happened to anyone?

Did you check you have redundancy license?

Yes I have license, point 186 in spadmin, E-CS redundancy.

Regards.

1 - OPS where present licence for redundancy - installed on working CPU (both CPU-Id present)?
2 - in netadmin (main CPU) - managed both CPU IP addresses and role addressing?
3 - in netadmin (twin CPU) - managed both CPU IP addresses and role addressing?

Hi,

1. Is present and working. Only appear one cpu_id.
2. It's OK
3. It's OK

The cpu stand-by never have de role stand-by, always put the role in "Undefined"

Stupid question - do you have Backup CPU cable between both CPUs connected on the backplane?

Yes, is connected and the jumper of cpu 7-2 in position to connect both cpu's to the customer's electronics.

Regards.

What "twin" command shows?

Hi

this should work, even without the second cpuid. You need to insert this second id in the businessportal, then you get a new .swk with both id´s

can you ping between the cpus?

Solved, the ops was bad create.

Regards.