Issue setting up GD3 board in Remote Shelf

[jbower]

I am trying to setup the Ethernet Param for a GD3 board for remote shelf. When I try to set the IP information i get an error message. I have attached what I tried to program in the attachment.

Ether Param.JPG

Then I get an error message that i also have attached.

error message.JPG

[patmul39]

you cannot manage the IP paramaters under the Ethernet Parameters of the GD - however you have to manage the MAC address. Then connect to the GD (manually, by serial cable) and manage the following:
Startup mode - Dynamic or Static
IP address
Netmask
Gateway address
TFTP server address - Your OXE main IP address
Callserver address
Crystal number - Manual entry or Dynamic allocation
VLAN menu - if you use VLAN or tagging packets (DSCP)

on your OXE you must already have your TFTP file available (lanpbxbuild)