OXE break E1 ISDN

[mokhtar ACFE]

hello,

Thank you in advance to those who could help me
I had to remove a board E1 ISDN ,but i have already this error

Delete \OmniBRN\Shelf::5\Board::3
Board Address : Term. are connected to the board

i delete all term connected to this board by deletin all trunk and trunk group .
Can any one help me .

[tgn]

what output do you have with command...
trkstat 5 3
regards...

[mokhtar ACFE]

thnk you , I have this output .
+------------------------------------------------------------------------------+
| T R U N K S T A T E - PRA T Coupler Crystal_nbr = 5 |
| OUT OF SERVICE Coupler Nbr = 3 |
+------------------------------------------------------------------------------+
| Access 0 Type : T2 access : ENABLED level2 : DCONNECT2 |
| |
| Trunk Grp |
| Channel 1 2 3 4 5 6 7 8 9 10 11 12 |
| State -- -- -- -- -- -- -- -- -- -- -- -- |
| |
| Trunk Grp |
| Channel 13 14 15 17 18 19 20 21 22 23 24 25 |
| State -- -- -- -- -- -- -- -- -- -- -- -- |
| |
| Trunk Grp |
| Channel 26 27 28 29 30 31 |
| State -- -- -- -- -- -- |
+------------------------------------------------------------------------------+
| F: Free | B: Busy | Ct: busy Comp trunk | Cl: busy Comp link |
| WB: Busy Without B Channel| Cr: busy Comp trunk for RLIO inter-ACT link |
| WBD: Data Transparency without chan.| WBM: Modem transparency without chan. |
| D: Data Transparency | M: Modem transparency |
+------------------------------------------------------------------------------+
| ALARM COUNTERS |
+------------------------------------------------------------------------------+
| NOS | AIS | LOS | FEC/CEC | RAI |
| 0 | 0 | 0 | 0 | 0 |
|------------------------------------------------------------------------------|
| NOS : no signal | LOS : loss of synchronization |
| AIS : alarm indication signal | FEC/CEC : Frame/Checksum error counter |
| RAI : remote alarm indication | |
+------------------------------------------------------------------------------+

[mokhtar ACFE]

Hi
the problem is solved, I changed the board by a new card E1 ISDN . Now i can delete all trunk group .
thanks

[tgn]

thx2 4 sharing

regards...

[vad]

Usually this happen - when we delete access but users use this TG. We cannot see access, but when we try to delete board or use access in another TG - PBX not allow this.
After PBX restart - access can be used/ board deleted. I use another solution - after some times - I delete access again (only via mgr) - delete the same access from the TG.
My opinion - when we delete access first time - access deleted from HDD database but not deleted from RAM database (access used). We cannot delete access from 4760 (access not present on HDD) but mgr allow to say - delete access X-XX-X from TG XXX