I connect an own Cisco device or Ericsson device with an OXE 8.0.1. The master is the Cisco side, the incoming calls works fine.
t3, tracer, mtrace logs are shows nothing.
I try to direkt trunk seizure.
In first I select the trunk, I get a tone, I can enter number, and a few seconds get the congestion message.
After this, when I select, I get immediately.
Number Compatible With : -1
Number Of Digits To Send : 4
+==============================================================================+
| T R U N K S T A T E Trunk group number : 97 |
| Trunk group name : Cisco ISDN |
| Number of Trunks : 2 |
+------------------------------------------------------------------------------+
| Index : 1 2 |
| State : F F |
+------------------------------------------------------------------------------+
| F: Free | B: Busy | Ct: busy Comp trunk | Cl: busy Comp link |
| WB: Busy Without B Channel| Cr: busy Comp trunk for RLIO inter-ACT link |
| WBD: Data Transparency without chan.| WBM: Modem transparency without chan. |
| D: Data Transparency | M: Modem transparency |
+------------------------------------------------------------------------------+
+------------------------------------------------------------------------------+
| T R U N K S T A T E - MIX44 Coupler Crystal_nbr = 3 |
| IN SERVICE Coupler Nbr = 2 |
+------------------------------------------------------------------------------+
| Access 0 Trunk Grp 97 97 Access 4 Trunk Grp |
| Type: .. State F F Type: State |
| |
| Access 1 Trunk Grp 98 98 Access 5 Trunk Grp |
| Type: T0 State F F Type: State |
| |
| Access 2 Trunk Grp Access 6 Trunk Grp |
| Type: .. State Type: State |
| |
| Access 3 Trunk Grp Access 7 Trunk Grp |
| Type: .. State Type: State |
| |
+------------------------------------------------------------------------------+
| F: Free | B: Busy | Ct: busy Comp trunk | Cl: busy Comp link |
| WB: Busy Without B Channel| Cr: busy Comp trunk for RLIO inter-ACT link |
| WBD: Data Transparency without chan.| WBM: Modem transparency without chan. |
| D: Data Transparency | M: Modem transparency |
+------------------------------------------------------------------------------+
15/10/18 15:51:09 000001M|003/02/0/001|=2:0239=Alarm level 1 or 2 TO/SO Eqt 846 info 1
Level 2 activation failure on O/G call (t3 - trace for next level, level3).
16/10/18 15:02:17 000001M|---/--/-/---|=3:1700=Protocol error Q931, type 4, access no 7
4 : Wrong length of the call reference
1 - Synchronization priority managed or not (infocs command)?
2 - Try to make outgoing call when you have established incoming call (via the same access)
Incoming t3 trace - for access 2-10-0.
When you trying outgoing call - was used the same access (2-10-0)?
Sometimes exist problem with outgoing calls - if no established calls - level 1 from remote site deactivated. In this case - or make incoming call (for SAME access) or manage permanent level 1 on remote (Cisco) site.