How to verify DCHP Configuration?

Post Reply
searching1
Member
Posts: 16
Joined: 18 Jun 2015 03:20

How to verify DCHP Configuration?

Post by searching1 » 18 Jun 2015 04:02

Hi,

We are using Omni 400 Pabx and how would I know who's giving Ip address on my IP phone.
CIsco Switch uses default Vlan
Cisco Router no Configuration for Ip phone.
On our DHCP server there no config for IP phone which is the segment is 10.34.62.X

Now from PaBX I verified using netadmin -m then dhcp config but the result is no "DHCP Configuration"
i run the command Ippstat and it displayed all 10.34.62.0 sgment.

tried to check my IPphone IP touch 4038 physically under the settings theres no display for static or dynamically assign only the ip addres.

thanks

User avatar
tgn
Member
Posts: 751
Joined: 30 Dec 2009 17:59
Location: Germany

Re: How to verify DCHP Configuration?

Post by tgn » 18 Jun 2015 04:25

output of command dhcplease on oxe?
regards...
--- back to basics... focus your eyes to the essential things... ---

searching1
Member
Posts: 16
Joined: 18 Jun 2015 03:20

Re: How to verify DCHP Configuration?

Post by searching1 » 18 Jun 2015 22:21

Hi,
I have input the command dhcplease but there is no display?
Do you think it manually configured on IP phone.

I'm new handling pabx system.
thanks

User avatar
Krusty65
Alcatel Unleashed Certified Guru
Alcatel Unleashed Certified Guru
Posts: 229
Joined: 26 Sep 2007 13:30
Location: Normally in a comms room

Re: How to verify DCHP Configuration?

Post by Krusty65 » 25 Sep 2015 02:36

To check the settings on the phone power it off and when it reboots and gets to 2 of 5 press the i key followed by #

You can then navigate to the IP settings to see if the phone is set for DHCP (dynamic) or static, might give you some more info

K.
When I was a boy of fourteen, my father was so ignorant I could hardly stand to have the old man around.
But when I got to be twenty-one, I was astonished at how much the old man had learned in seven years.

Post Reply

Return to “DHCP Configuration”