Hi,
We are using Omni 400 Pabx and how would I know who's giving Ip address on my IP phone.
CIsco Switch uses default Vlan
Cisco Router no Configuration for Ip phone.
On our DHCP server there no config for IP phone which is the segment is 10.34.62.X
Now from PaBX I verified using netadmin -m then dhcp config but the result is no "DHCP Configuration"
i run the command Ippstat and it displayed all 10.34.62.0 sgment.
tried to check my IPphone IP touch 4038 physically under the settings theres no display for static or dynamically assign only the ip addres.
thanks
How to verify DCHP Configuration?
Re: How to verify DCHP Configuration?
output of command dhcplease on oxe?
regards...
regards...
--- back to basics... focus your eyes to the essential things... ---
-
- Member
- Posts: 16
- Joined: 18 Jun 2015 03:20
Re: How to verify DCHP Configuration?
Hi,
I have input the command dhcplease but there is no display?
Do you think it manually configured on IP phone.
I'm new handling pabx system.
thanks
I have input the command dhcplease but there is no display?
Do you think it manually configured on IP phone.
I'm new handling pabx system.
thanks
- Krusty65
- Alcatel Unleashed Certified Guru
- Posts: 242
- Joined: 26 Sep 2007 13:30
- Location: Normally in a comms room
Re: How to verify DCHP Configuration?
To check the settings on the phone power it off and when it reboots and gets to 2 of 5 press the i key followed by #
You can then navigate to the IP settings to see if the phone is set for DHCP (dynamic) or static, might give you some more info
K.
You can then navigate to the IP settings to see if the phone is set for DHCP (dynamic) or static, might give you some more info
K.
When I was a boy of fourteen, my father was so ignorant I could hardly stand to have the old man around.
But when I got to be twenty-one, I was astonished at how much the old man had learned in seven years.
But when I got to be twenty-one, I was astonished at how much the old man had learned in seven years.