Alcatel Unleashed

Posted: **14 Oct 2011 02:53**

Hello,

Can I modify the parameters "FlexLM Licensing Enabled" to NO (SYSTEM/LICENSES)

FlexLM Licensing Enabled + YES => NO
Flex Server IP Address : 172.16.3.1

Will a panic flag appears or no?

It's for a problem on my PCS, when I put the parameter to NO, the panic flag desappears. But when the psccopy is done, the parameter goes back to YES (as it's configured on VMoxe).

Thanks for your help

Julien

Posted: **18 Oct 2011 06:27**

It should be "Use Flex License" NO and "ProductID discovery" "Yes"....
"Use Flex License" is for another feature. Not for BiCS.
In your BiCS you can switch off "Use Flex License" w/o problems.

Posted: **20 Oct 2011 08:40**

I have verified on a other bics (R2.1). These parameters are the same :
FlexLM Licensing Enabled + "YES"
Flex Server IP Address : "Bics's @ip"

Posted: **20 Oct 2011 08:58**

But FlexLicensing is for RSI licensing only from my point of view.
So I would say the other BiCS is configured incorrectly too.

Posted: **20 Oct 2011 09:10**

This parameter is pre-configured with the Bics Wizard.

Alcatel Unleashed

BICS - CAN VMOXE FOUND ITS LICENSES ON OXE INSTEAD OF ON BIC

BICS - CAN VMOXE FOUND ITS LICENSES ON OXE INSTEAD OF ON BIC

Re: BICS - CAN VMOXE FOUND ITS LICENSES ON OXE INSTEAD OF ON

Re: BICS - CAN VMOXE FOUND ITS LICENSES ON OXE INSTEAD OF ON

Re: BICS - CAN VMOXE FOUND ITS LICENSES ON OXE INSTEAD OF ON

Re: BICS - CAN VMOXE FOUND ITS LICENSES ON OXE INSTEAD OF ON