SOFTWARE AND SYSTEM DATA MUST BE IN CABINET 0 OR 1

[greatfaheem]

Hi,
I am facing the following issue;

lcatel 4635

Prom Resident Test Demon, Integrated Version


Board Self-Test Status:



CPU Test........................................... PASSED
Console Test....................................... PASSED
Data/Stack RAM Test................................ PASSED
MTA Support ....................................... ENABLED
XOFF/XON Timeout .................................. ENABLED
Scrubbing all "known" DRAM memory ..... (00000000-04000000)
C67 test nb# 0 enabled
C67 test nb# 1 enabled
C67 test nb# 2 enabled
C67 test nb# 3 enabled
C67 test nb# 4 enabled
C67 test nb# 5 enabled
C67 test nb# 6 enabled
C67 test nb# 7 enabled
Timer Test......................................... PASSED

Copyright 1994-2006 Alcatel
System CPU PROM Version: e108VPU5 (Oct 31, 2006 15:41:55)

Board Type is: VPU5
VP_DIAG: RUN *
Display (But NOT Execute) Self-Test Status......... (00) STARTED PASSED
DRAM Walking 1s DWORD Test......................... (33) STARTED * * * * * * * * * * * * * * * * * * * * PASSED
DRAM 3Par DWORD Test Executed From DRAM............ (7D) STARTED * * * * * *** * * * * PASSED
Write/Verify Misc Registers........................ (2F) STARTED PASSED
Ethernet Test...................................... (74) STARTED PASSED
IPoC Controller Test............................... (4A) STARTED PASSED
IDE Disk Configuration............................. (50) STARTED
X.
IDE Disk Configuration............................. (50) PASSED
IDE Disk Drive Diagnostic.......................... (4D) STARTED PASSED
IDE Disk Read Test................................. (4E) STARTED PASSED
Crystal-1 Chip Test................................ (56) STARTED PASSED
C67 DSP Functional Test............................ (20) STARTED * * * * * * * * * * * * * * * * * * * * * * * PASSED
Watch Dog Timer.................................... (5F) STARTED PASSED

Please select from the following:

B Boot the System
^DB Boot the System (clear autoboot, set SRAM=0xFF)
^DD Run Diagnostics Interactively

Selection->
No response...
- Beginning OS BOOT process

[4635J] Initial Program Load Phase 1 (IPL1) Begins

Scrubbing all "known" DRAM memory ..... (00000000-04000000)

PIPL Version : 0226
Board Type : VPU5
Storage Type : IDE
System Type : A4635V

Looking for Combo File System...


*** SOFTWARE AND SYSTEM DATA MUST BE IN CABINET 0 OR 1 ***


*** SOFTWARE AND SYSTEM DATA MUST BE IN CABINET 0 OR 1 ***

FILE SYSTEM CONFIGURATION:

FILE SYSTEM CABINET CABINET CABINET CABINET
TYPE 0 1 2 3
----------- --------- --------- --------- ---------
SOFTWARE X
SYSTEM DATA X
PHRASES
MESSAGES X
----------- --------- --------- --------- ---------

ENTER FILE SYSTEM TYPE TO CHANGE:

A - SOFTWARE
B - SYSTEM DATA
C - PHRASES
D - MESSAGES
X - EXIT

SELECT OPTION: X


Can someone help?

[vad]

Show "config all" from your PBX.