4635 VPU5 will not boot
4635 VPU5 will not boot
upon start up it says...
*** WARNING !! Power Station Alarm Present ***
*** WARNING !! Board Is Not Able To Boot ***
Anyone know solution?
thanks
*** WARNING !! Power Station Alarm Present ***
*** WARNING !! Board Is Not Able To Boot ***
Anyone know solution?
thanks
-dan
OXE/OXO ACFE
8770 ACFE
AVST Technician
OXE/OXO ACFE
8770 ACFE
AVST Technician
Re: 4635 VPU5 will not boot
also have this message.....
WARNING !! RESETTING and RESTARTING VPU5 Board, due to:
"Power Station Alarm Present"
(initiated by "user module")
WARNING !! RESETTING and RESTARTING VPU5 Board, due to:
"Power Station Alarm Present"
(initiated by "user module")
-dan
OXE/OXO ACFE
8770 ACFE
AVST Technician
OXE/OXO ACFE
8770 ACFE
AVST Technician
Re: 4635 VPU5 will not boot
Nevermind found solution.thanks
-dan
OXE/OXO ACFE
8770 ACFE
AVST Technician
OXE/OXO ACFE
8770 ACFE
AVST Technician
- tot3nkopf
- Alcatel Unleashed Certified Guru
- Posts: 4058
- Joined: 02 Feb 2006 10:41
- Location: Germany & Romania
- Contact:
Re: 4635 VPU5 will not boot
Would you mind share it for future reviews?d-mgr wrote:Nevermind found solution.thanks
Re: 4635 VPU5 will not boot
too simple
PSAL cable became disconnected
PSAL cable became disconnected
-dan
OXE/OXO ACFE
8770 ACFE
AVST Technician
OXE/OXO ACFE
8770 ACFE
AVST Technician
Re: 4635 VPU5 will not boot
I recently had the same problem. After reviewing the psal it was OK, the problem has been on the shelf. Whit a new shelf all was OK.
Re: 4635 VPU5 will not boot
Hi.
I've got the same problem. Can you please tell me what is PSAL cable and where it could be found?
I've got the same problem. Can you please tell me what is PSAL cable and where it could be found?
Re: 4635 VPU5 will not boot
On the back plane - you have power connection (filter box - with red/blue cable for 48V DC and brown PSAL cable).
PSAL signal = "-48V" during normal operation.
PSAL signal = "-48V" during normal operation.
Re: 4635 VPU5 will not boot
OK, I got it. We've moved cabinets to standard rack from original Alcatel and not connect this wire. Do I need to have the green light which is in original rack or there is only need to connect brown wire to -48V?
Re: 4635 VPU5 will not boot
The best solution (if you have power supply with battery) - to install "green light" (PSAL).
In case of main power failure system will work from battery and you will have PSAL alarm when voltage will drop below 46V.
System will shutdown correctly.
You can connect -48V instead of PSAL signal - in this case you can have problem when something happen with power supply.
In case of main power failure system will work from battery and you will have PSAL alarm when voltage will drop below 46V.
System will shutdown correctly.
You can connect -48V instead of PSAL signal - in this case you can have problem when something happen with power supply.