Hi Folks,
I have an issue where pressing the keys on the MY IC on screen keypad during a call is sending two DTMF tones instead of one. Pressing the numbers on the physical handset works ok and is sending only one tone per key press. Tested and confirmed on 2 different phones and PCs on multiple calls.
Software details are: OmniTouch 8400 ICS version 2.7.200.001 running on 64 bit Windows 7.
This did not happen on the older version of ICS, however we have also upgraded our OXE and I can't be sure when the issue first started, but leaning towards the new ICS client working ok for a while.
Can someone tell me if there is an setting somewhere to tell how many tones to send with each onscreen key press or if this is a known issue? Thanks!
Regards,
g@z.
My IC keypad sending two tones instead of one
- cavagnaro
- Alcatel Unleashed Certified Guru
- Posts: 7014
- Joined: 14 Sep 2005 19:45
- Location: Brasil, Porto Alegre
- Contact:
Re: My IC keypad sending two tones instead of one
Search the forum. Same question was done a few time ago
Sent from my XPeria Z
Sent from my XPeria Z
Ignorance is not the problem, the problem is the one who doesn't want to learn
OTUC/ICS ACFE/ACSE R3.0/4.0/5.0/6.0
Certified Genesys CIV 8.5
Certified Genesys Troubleshooting 8.5
Certified Genesys BEP 8.x
Genesys Developer
OTUC/ICS ACFE/ACSE R3.0/4.0/5.0/6.0
Certified Genesys CIV 8.5
Certified Genesys Troubleshooting 8.5
Certified Genesys BEP 8.x
Genesys Developer
Re: My IC keypad sending two tones instead of one
Thanks mate,
I did try searching but it's guessing the wording that other people use to describe the same issue that's difficult
Regards,
g@z.
I did try searching but it's guessing the wording that other people use to describe the same issue that's difficult
Regards,
g@z.
Re: My IC keypad sending two tones instead of one
Ok I used some other terms and found the thread I think you were talking about: viewtopic.php?f=285&t=22061&p=78436&hil ... nes#p78436
Seems to have occurred after an upgrade from 9 to 10 just like we have done. No solution offered as yet however. Thanks.
Regards,
g@z.
Seems to have occurred after an upgrade from 9 to 10 just like we have done. No solution offered as yet however. Thanks.
Regards,
g@z.