Dear All,
Does any one know how I can control on the duration of the Disa message?, I have about 25 sec. Disa message and it is repeated 4 times before going to attendant when an external caller dial the external trunk connected to the PBX, so we need to repeat it 2 times only instead of 4 times. How can I do that?
for your information, the PBX is OXE-R9.1-Crystal HW
Regards,
Aldorado
Disa Message Duration in OXE
- frank
- Alcatel Unleashed Certified Guru
- Posts: 3169
- Joined: 06 Jul 2004 00:18
- Location: New York
- Contact:
Re: Disa Message Duration in OXE
Did you look in the list of the timers in the documentation ?
Code Free Or Die
Re: Disa Message Duration in OXE
Hi Frank,
sure, but I found that, there is a timer enable me to control on the time before the Disa answering the incoming call,(how many rings for the caller before hearing the Disa message).
Regards,
Aldorado
sure, but I found that, there is a timer enable me to control on the time before the Disa answering the incoming call,(how many rings for the caller before hearing the Disa message).
Regards,
Aldorado
Re: Disa Message Duration in OXE
Is it inter digit timeout? By default 10 not 25 seconds?! Stop the time and check matching entries in tabtemp command output step by step