Hi All,
Anyone know why star mark (*) not dissapear after I do admin save/bof save ? The saving proccess is completed.
*A:ABC# admin save
Writing configuration to cf3:\config.cfg
Saving configuration ... OK
Syncing configuration:
boot option file : cf3:\bof.cfg ... OK
primary config : cf3:\config.cfg ... OK
primary config : cf3:\config.ndx ... OK
Completed.
*A:ABC#
Thank you
* Mark cannot dissapear after save
Re: * Mark cannot dissapear after save
I've seen this on systems running LI (Leagal Inspection).
Not sure why, as I have not had the opportunity to troubleshoot it.
I have also seen it on chassis that had some strange behaviour. Reboot of the node cured those.
Not sure why, as I have not had the opportunity to troubleshoot it.
I have also seen it on chassis that had some strange behaviour. Reboot of the node cured those.
[flash=]
Christoffer
Network System Expert Norway
Nokia SRA #265
Alcatel-Lucent SRC 3RP Certified #552
Alcatel-Lucent SRC NRS-2 Certified #1104
Huawei HCNP Routing & Switching certified
Cisco CCNP Certified
LinkedIN
[/flash]
Christoffer
Network System Expert Norway
Nokia SRA #265
Alcatel-Lucent SRC 3RP Certified #552
Alcatel-Lucent SRC NRS-2 Certified #1104
Huawei HCNP Routing & Switching certified
Cisco CCNP Certified
[/flash]
Re: * Mark cannot dissapear after save
There are a couple of resolved bugs that might be relevant depending on what software/features you are running:
An asterisk (*) indicating a configuration change no longer appears at the CLI prompt after an L2TP session is established or deleted.
A VRRP state change in a routed VPLS will no longer cause an asterisk to appear before the router prompt as if a configuration change had occurred.
An asterisk (*) indicating a configuration change no longer appears at the CLI prompt after an L2TP session is established or deleted.
A VRRP state change in a routed VPLS will no longer cause an asterisk to appear before the router prompt as if a configuration change had occurred.