7750 SR1-e IES - 7210 SAS-S Epipe qinq

[farroo]

Hi All,
coming from a juniper background and adapted Nokia so please excuse the daftness.
What i am after is to find a way to have a qinq sap on 7210- mpls lsp to 7750 where i have an IES with just an L3 interface.

in Juniper we have something like
mx router
int xe* - unit 100 outer tag 100 inner tag 10
family inet address 172.16.1.1/30
unit 200 outer tag 100 inner tag 20
family inet address 172.17.1.1/30 and so on--
||||| Carrier||||
|||||||
CPE:
vlan 10 : address 172.16.1.2/30
vlan 20 : address 172.17.1.2/30

carrier do qinq and hand off all the customer traffic on our MX tag 100.

Need to have a similar setup - which will replace MX by 7750 sr-1 and carrier device by 7210 SAS.
Diagram attached to illustrate.

Topolgy: 7750--------DF link-----(RSVP-TE)-------7210-SAS========CPE

[thekotaksampah]

Hi,

is it mandatory using qinq in your set up since your Sr-1e and SAS-S running MPLS and you already use pseudowire tunnel towards SAS with VC:100?

So in your 7750SR1 will have two interfaces using IES service and these IES interfaces will have spoke-sdp (pseudowire tunnel) towards SAS. in SAS what service you plan to deploy? is it L2VPN VPWS or VPLS?