LACP - linkagg Testing

[jpattard]

I configured LACP on a Stack of two OS 6350-24. If i disconnect 1 of the ports the link is still working, but if i remove both ports and put them back after a few seconds it does not get back up. Below is the config on these switches.

-> show linkagg

Number Aggregate SNMP Id Size Admin State Oper State Att/Sel Ports
-------+----------+---------+----+------------+--------------+-------------
1 Static 40000001 2 ENABLED UP 2 2

Slot/Port Aggregate SNMP Id Status Agg Oper Link Prim
---------+---------+-------+----------+----+----+----+----
1/2 Static 1002 ATTACHED 1 UP UP NO
2/2 Static 2002 ATTACHED 1 UP UP YES

-> show 802.1q 1

Tagged VLANS Internal Description
-------------+------------------------------------------+
2 TAG AGGREGATE 1 VLAN 2
100 TAG AGGREGATE 1 VLAN 100

[silvio]

You haven't configured LACP. Your LAG is static. I recommend to reconfigure both switches with LACP and try again.
regards
Silvio

[jpattard]

In the mean time have reconfigured the switch with dynamic LACP but it still takes time to failover to the other switch. See config below:
! Port Mapping :
! Link Aggregate :
lacp linkagg 1 size 2 admin state enable
lacp linkagg 1 actor admin key 1
lacp agg 1/2 actor admin key 1
lacp agg 2/2 actor admin key 1
! VLAN AGG:
! 802.1Q :
vlan 2 802.1q 1/1 "TAG PORT 1/1 VLAN 2"
vlan 100 802.1q 1/1 "TAG PORT 1/1 VLAN 100"
vlan 2 802.1q 1/3 "TAG PORT 1/3 VLAN 2"
vlan 100 802.1q 1/3 "TAG PORT 1/3 VLAN 100"
vlan 2 802.1q 1 "TAG AGGREGATE 1 VLAN 2"

[silvio]

which device is at the other end of the linkagg? Have you configured there also LACP?