First check that soe (serial over ethernet) is activated in your controller.
When your AP is connected to the APC throught your cable, you will see the autoboot sequence. Follow this sequence :
apboot > purge
apboot > save
Erasing ...
Programming ...
Verifying ...
Hi , I have 70 ap (ap60,61) provisioned and working. but i have a Ap where the controller no see the ap o the ap fails now i need factory default the AP to verify the ap is good.
if I still the steps. lost the others ap configured ??
apboot> purge
apboot> save
Erasing....
Programming...
Verifying....