I am trying to make a network topology as follows
The idea is to try to get the ip's of vlan 2 and 4 to the other end through an epipe or vpls using qinq on the ports of the Nokia router that connects to the sw_cisco.
I have the following configurations
switch
Code: Select all
interface Ethernet0/0
description to_nokia_A
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 2,4
switchport mode trunk
duplex auto
Code: Select all
interface Ethernet0/1
description pc1_vlan2
switchport access vlan 2
switchport mode access
duplex auto
Code: Select all
A:Nokia_A# configure port 1/1/4
A:Nokia_A>config>port# info
----------------------------------------------
ethernet
mode access
encap-type qinq
exit
no shutdown
----------------------------------------------
A:Nokia_A>config>port#
Code: Select all
A:Nokia_A# show service sdp
============================================================================
Services: Service Destination Points
============================================================================
SdpId AdmMTU OprMTU Far End Adm Opr Del LSP Sig
----------------------------------------------------------------------------
109 0 8682 10.100.10.5 Up Up MPLS R TLDP
----------------------------------------------------------------------------
Number of SDPs : 1
----------------------------------------------------------------------------
Legend: R = RSVP, L = LDP, B = BGP, M = MPLS-TP, n/a = Not Applicable
I = SR-ISIS, O = SR-OSPF, T = SR-TE, F = FPE
============================================================================
A:Nokia_A#
Code: Select all
A:Nokia_A# show service service-using
===============================================================================
Services
===============================================================================
ServiceId Type Adm Opr CustomerId Service Name
-------------------------------------------------------------------------------
10 Epipe Up Up 1
2147483648 IES Up Down 1 _tmnx_InternalIesService
2147483649 intVpls Up Down 1 _tmnx_InternalVplsService
-------------------------------------------------------------------------------
Matching Services : 3
-------------------------------------------------------------------------------
===============================================================================
A:Nokia_A#
Code: Select all
*A:Nokia_A>config>service>epipe# info
----------------------------------------------
sap 1/1/4:2.* create
no shutdown
exit
spoke-sdp 109:10 create
no shutdown
exit
no shutdown
------------------------
My question is, is what I am trying to do achievable or is there something missing to make it work?
Any ideas are welcome, thanks