Hello all.
I have 3 GD-3 and 2 GA-3 with the same problem, when I try to connect via V24 port for the configuracion, always appears a inicial message and don´t let me type CTRL+B and CTRL+I for entry to the boot menu.
This is the message:
U-Boot 1.3.0-rc3 (Mar 5 2010 - 11:50:23) 3EH30350AAAM bootl10
U-Boot 1.3.0-rc3 (Mar 5 2010 - 11:50:23) 3EH30350AAAM bootl10
U-Boot 1.3.0-rc3 (Mar 5 2010 - 11:50:23) 3EH30350AAAM bootl10
U-Boot 1.3.0-rc3 (Mar 5 2010 - 11:50:23) 3EH30350AAAM bootl10
U-Boot 1.3.0-rc3 (Mar 5 2010 - 11:50:23) 3EH30350AAAM bootl100
U-Boot 1.3.0-rc3 (Mar 5 2010 - 11:50:23) 3EH30350AAAM bootl100
Always the same in all boards and I can do anything.
Some one has this problem too? anyone knows how to correct it?
Thanks a lot.
Schelbin Erik Leal
Error booting GD-3
Error booting GD-3
Schelbin Erik
Bogotá, Colombia S.A.
Bogotá, Colombia S.A.
-
- Alcatel Unleashed Certified Guru
- Posts: 929
- Joined: 30 Jan 2006 09:40
- Location: Argentina
- Contact:
Re: Error booting GD-3
Hi. The only board you need to configre is GD3. Wait until boot finish and you will have to prompt to configure it. GA3 is configure from OXE. Regards.
ACSE R11
OT R2.0
OT R2.0
Re: Error booting GD-3
Hi,
You have to connect LAN-Port of GD-3 to a switch so link-state is up. Then GD-3 boots normal until login prompt.
Regards
LT
You have to connect LAN-Port of GD-3 to a switch so link-state is up. Then GD-3 boots normal until login prompt.
Regards
LT
Re: Error booting GD-3
Al Salamu 3alykom, Dear Schelbin,
Try to use the DHCP of the system to assign IP automatically to the GD using static assignment via GD MAC address
Try to use the DHCP of the system to assign IP automatically to the GD using static assignment via GD MAC address
Re: Error booting GD-3
I have tried all the suggestions made on the U boot error; activity on LAN port still i don't get the login prompt. This is with and without the CS.
Any further suggestions?
Regards
GM
Any further suggestions?
Regards
GM
- Jtmurphy76
- Member
- Posts: 27
- Joined: 17 Nov 2010 01:18
- Location: South Africa, Cape Town
- Contact:
Re: Error booting GD-3
Good day Shelbin
Did you ever get a solution to this problem.
I have this issue at the moment
Did you ever get a solution to this problem.
I have this issue at the moment
Re: Error booting GD-3
in which position you install gd3 board? it should always be position 0 of the rack
also check the dip switch on the board. are they on the correct position (on/off). advice documentation for that.
also check the dip switch on the board. are they on the correct position (on/off). advice documentation for that.