Page 1 of 1

OXE R100.1 SIP trunk 403 after kill sipmotor

Posted: 22 Mar 2024 19:05
by morio
hi all,
once again another issue with sip trunk, something strange. if a kill the sipmotor i can not make any incoming calls. oxe reply with 403. but i can make a out going call. and once the out going call is done, i recieve incoming calls. that also if the sip trunk is not busy for about 2 hours again i dont have incoming calls until i make one out going call. traces will be attached, please assist me onthis pls..

thanks in advance

Re: OXE R100.1 SIP trunk 403 after kill sipmotor

Posted: 22 Mar 2024 19:06
by morio
please finf the traces herewith,,,

Re: OXE R100.1 SIP trunk 403 after kill sipmotor

Posted: 24 Mar 2024 22:51
by vad
Looks like SW error.

Re: OXE R100.1 SIP trunk 403 after kill sipmotor

Posted: 24 Mar 2024 22:55
by vad
Or you have problem with NAT table on router.

Re: OXE R100.1 SIP trunk 403 after kill sipmotor

Posted: 26 Mar 2024 04:40
by morio
thanks for the reply, yes i am planing to patch upgrade it, since the running patch is quite old. it could be a BUG as usual. i will keep it posted.

thanks again

Re: OXE R100.1 SIP trunk 403 after kill sipmotor

Posted: 07 Jul 2024 03:36
by morio
problem resolved after replacing the SBC (Cisco 2900 series )