OUTPUT CONFIGURATION
This table allows for the conversion of characters from the system to the terminals (see output attribute in DATA TERMINAL).
By default, the table used is table No. 0.
Output Config. Id
16 configurations can be managed (0 to 15); they are created by default with the same parameter values.
Output configuration No. 0 is the one for reference; it cannot be modified. It is the configuration at initialization.
Used
YES: used by at least one DATA station
Unused
Not used
The menu offers the following choices:
0 No conversion,
1 To upper case,
2 To lower case.
LF After CR
The following sections make it possible to choose the character for the RETURN command (carriage return):
In command mode (message mode on the menu)
YES: the CR LF command is used in the command mode.
NO: the LF command is used in the command mode.
In connected mode (data mode on the menu)
YES: the CR LF command is used in connected mode.
NO: the LF command is used in connected mode.
Local Echo
The following sections make it possible to choose the local echo mode (with or without):
In command mode
YES: the local echo is used in command mode.
In connected mode
YES: the local echo is used in connected mode.
Unused
Not used
Unused
Not used
Unused
Not used