Hello all.
I am facing and extrange trouble on an Mediagateway.
OXE Common Hardware with two shelfs. Shelf 2 (main) and shelf 3 connected throug a MEX Board.
All boards in shellf two works fine.
Shef 3 have two GA boards working fine (on slots 1 and 3).
If I install any other type of board, in any other abailable slots (2, 4, 5, 6, 7 or the boards did not enter in service. I´m trying to install UAI16, UA8, SLI16 and SLI8 boards and no one get into service on shelf 3.
I tested all this boards on shelf 2 and are fine, all boards got in service inmmediatly on shelf 2.
Any suggestion of What can be happen that boards UAIx and SLIx are not getting into service on shelf 3.
Regars
AFLORES
Meida Gateway did not recognise some boards.
Meida Gateway did not recognise some boards.
_________________________________________________
Nobody is so wise that needs no help, no one is so ignorant as not to deserve it.
Nobody is so wise that needs no help, no one is so ignorant as not to deserve it.
Re: Meida Gateway did not recognise some boards.
GA boards need only power and TCP connevtion with the CPU, that's why they work. So check MEX and HSL boards first.
If it looks like a duck, swims like a duck, and quacks like a duck, then it probably is a duck.
Re: Meida Gateway did not recognise some boards.
Hello Alex, I forgot to mention that if I did an config 3 I got this result:
+-------------------------------------------------------------------+
| Cr | cpl| cpl type | hw type | cpl state | coupler ID |
|----|----|------------|-----------|--------------|-----------------|
| 3 | 0 | MEX|---------- | IN SERVICE | NO PCMS CODE |
| 3 | 1 | GA|---------- | IN SERVICE | BAD PCMS CODE |
| 3 | 2 | SLI 16(Z)|---------- | REG NOT INIT | NO PCMS CODE |
| 3 | 3 | GA|---------- | IN SERVICE | BAD PCMS CODE |
| 3 | 6 | APA 8|---------- | REG NOT INIT | BAD PCMS CODE |
| 3 | 7 | APA 8|---------- | REG NOT INIT | BAD PCMS CODE |
+-------------------------------------------------------------------+
So, no matter that result, the MEX or HSL dagther board should be damage?
Thanks for your reply.
AFLORES
+-------------------------------------------------------------------+
| Cr | cpl| cpl type | hw type | cpl state | coupler ID |
|----|----|------------|-----------|--------------|-----------------|
| 3 | 0 | MEX|---------- | IN SERVICE | NO PCMS CODE |
| 3 | 1 | GA|---------- | IN SERVICE | BAD PCMS CODE |
| 3 | 2 | SLI 16(Z)|---------- | REG NOT INIT | NO PCMS CODE |
| 3 | 3 | GA|---------- | IN SERVICE | BAD PCMS CODE |
| 3 | 6 | APA 8|---------- | REG NOT INIT | BAD PCMS CODE |
| 3 | 7 | APA 8|---------- | REG NOT INIT | BAD PCMS CODE |
+-------------------------------------------------------------------+
So, no matter that result, the MEX or HSL dagther board should be damage?
Thanks for your reply.
AFLORES
_________________________________________________
Nobody is so wise that needs no help, no one is so ignorant as not to deserve it.
Nobody is so wise that needs no help, no one is so ignorant as not to deserve it.