While trying to troubleshoot some issues on one of our switches, I came across a few errors that I can't decipher, could you perhaps help me out?
First, we noticed that 1/1/12 went down quite regularly, and I have tried looking into logs to figure it out.
The port itself looks fine:
Code: Select all
show interfaces port 1/1/12
Chassis/Slot/Port : 1/1/12
Operational Status : down,
Port-Down/Violation Reason: None,
Last Time Link Changed : Fri Aug 12 15:49:37 2022,
Number of Status Change : 2354,
Type : Ethernet,
SFP/XFP : N/A,
Interface Type : Copper,
EPP : Disabled,
Link-Quality : N/A,
MAC address : XXX.XXX.XXX.XXX,
BandWidth (Megabits) : - , Duplex : -,
Autonegotiation : 1 [ 1000-F 100-F 100-H 10-F 10-H ],
Long Frame Size(Bytes) : 9216,
Inter Frame Gap(Bytes) : 12,
loopback mode : N/A,
Rx :
Bytes Received : 17810895848, Unicast Frames : 65363829,
Broadcast Frames: 25397, M-cast Frames : 460206,
UnderSize Frames: 0, OverSize Frames: 0,
Lost Frames : 0, Error Frames : 0,
CRC Error Frames: 0, Alignments Err : 0,
Tx :
Bytes Xmitted : 143070803770, Unicast Frames : 124511061,
Broadcast Frames: 51994200, M-cast Frames : 81366341,
UnderSize Frames: 0, OverSize Frames: 0,
Lost Frames : 0, Collided Frames: 0,
Error Frames : 0, Collisions : 0,
Late collisions : 0, Exc-Collisions : 0
The errors I need help with are:
Code: Select all
swlogd intfNi Drv INFO: eniApplyConfig: cmd:34 zport:11 cmdHy:0, apMedia:2
swlogd portMgrNi main INFO: : [pmnHALLinkStatusCallback:206] LINKSTS 1/1/12 DOWN (gport 0xb) Speed 10 Duplex HALF
swlogd stpNi _SOKt INFO: stpnimsg_processMsgFromPM: PM_LINK_STATUS_MSGID gPort=xb linkStatus=0
swlogd intfNi Drv INFO: niEsmSendLinkStatusChgMsg(1058): linkstatus DOWN sent on peerId=1
swlogd intfCmm Mgr EVENT: CUSTLOG CMM Link 1/1/12 Alias XXXXX operationally down
swlogd intfCmm Mgr INFO: cmmEsmHandleNiMsg: Rx CMM_ESM_LINK_STATUS_CHG from chassis 1 NI 1
swlogd portMgrNi main INFO: : [pmnHALLinkStatusCallback:206] LINKSTS 1/1/12 UP (gport 0xb) Speed 1000 Duplex FULL
Mainly what interest me is:
- eniApplyConfig: cmd:34 zport:11 cmdHy:0, apMedia:2
- [pmnHALLinkStatusCallback:206]
Thanks as always!