Timers for Z board

Post by **vad** » 18 Jan 2010 07:54

Try to play with timer 54 - New answer timer.

The user hangs up while making an external call, if he unhooks during this timer, he is again connected to the network. Can be reduced to 1 sec.

Not manage value 1.

andriuja · Post by **andriuja** » 19 Jan 2010 01:50

Dear Vad,
This timer is only for analog sets?
Or it will be changed for digital?

Post by **vad** » 19 Jan 2010 02:15

Not sure. Just try. When you change timer - new value used immediate (not necessary to reset PBX).

andriuja · Post by **andriuja** » 19 Jan 2010 04:07

It's quite difficult, because we have a lot of services on our PABX, 24 Hours.
That is why I need to know exactly about which timer introduce dellay.

Ok. When it will be possible to restart, I will tell you about result.

Post by **vad** » 19 Jan 2010 04:11

restart not needed!!! Just change timer and check.

Post by **vad** » 19 Jan 2010 06:03

Some additional questions:
- type of external connection (ISDN, R2...)?
- analog sets - usual users or not? CC agent,..?
- outgoing connection - usual via prof TG seizure or ARS?

andriuja · Post by **andriuja** » 19 Jan 2010 06:33

Dear Vad,

Timer T54 was changed from 25 to 10 (10= 1 sec, am I wright?) - the same situation. Delay remain.

Regarding your additional questions:
-Type of external connection - ISDN
- analog sets are usual users (not agent, not group.....)
- outgoing connection via prof TG seizure.

Call from analog to external via ISDN trunk.
In case of call from digital set release comes immediatly, but in case of analog sets with delay.

andriuja · Post by **andriuja** » 20 Jan 2010 08:45

Do you have any ideas?

Eliott · Post by **Eliott** » 10 Feb 2010 15:15

Is CLIP used?

andriuja · Post by **andriuja** » 11 Feb 2010 16:23

NO, it's not used.
I don's see any relations between CLIP and Delay....? What do you mean?