Audio parameters for analog phone

mbaledent · Post by **mbaledent** » 18 Feb 2010 08:53

Hi all,

Do someone know if it is possible to adjust the sound volume using mgr for phones connected to the OXE through SLI board.

I "played" with parameters in system>Z board Audio Parameters but nothing changed. Do I have to restart the SLI coupler after modification ?

Regards,

M.B.

Post by **tot3nkopf** » 18 Feb 2010 09:11

mbaledent wrote:
Do I have to restart the SLI coupler after modification ?

Regards,

M.B.

Yes. Restart of the coupler is needed.

Eliott · Post by **Eliott** » 19 Feb 2010 18:08

Yes to have to restart and yes it's possible AND it's possible also for just one board (using the Dynamic Init Parameters) but that way is very difficult and not suggested if not absolutely needed.

mbaledent · Post by **mbaledent** » 22 Feb 2010 03:41

Hi,

Thanks for you answers.

In fact, I'll try to adjust those parameters because the audio sound is too loud and by the way sometimes a little bit scratching. But I don't exactly know with which parameters sould I play and nothing about that appears on the Alcatel documentation. If you have an idea where I can find those informations ?

Best Regards,

M.B.