My cpu can not take the role of Main

opencom · Post by **opencom** » 28 Jun 2010 10:00

Hi to everyone,
when I logged in PBX system, The Main cpu had undefine role while the slave CPU had already taken the role of main. The message from the command "role" is "Erreur mapping sur REMAGEN -7".

Any suggestion would be appreciated.
Thank you in Advance for your time

Post by **vad** » 29 Jun 2010 00:21

Check - autostart set or not. Maybe after some problem CPU restarted - if autostart not set - telephone application not started and CPU cannot be main or stand-by.

opencom · Post by **opencom** » 29 Jun 2010 08:59

thanks for your reply,

Please let me know how I could check the "autostart"?
Furthermore, I will start the telephone service

btlasisi · Post by **btlasisi** » 29 Jun 2010 09:43

You can set the autostart and start the telephone on swinst menu. You can also run RUNTEL command after setting your autostart on swinst menu.

Post by **vad** » 29 Jun 2010 23:18

swinst/ expert menu/ system manaagement/ autostart management

mustafa.ahmad · Post by **mustafa.ahmad** » 07 Jul 2010 14:44

give "shutdown -r now" command on the slave cpu ... then the slave cpu will go for shutdown and the main cpu will assume the role of main....
also check if you have done proper role addressing in netadmin .. menu 5...

capeini · Post by **capeini** » 12 Jul 2010 03:56

You can go into Swinst meny / Easy menu and select "Start the telephone".
Then the autostart will be set, and the system will start-up.

Remember that the best option to start the standby-CPU is to do a mastercopy, and select to start the telephone after it's done. Then you will have a completely synced system