4635 acess using RMA and MOD boards

beirut · Post by **beirut** » 14 Jul 2010 19:55

Anybody knows if is it possible to configure the minicom or 4635 V24 acess when using the RMA MOD board.

Post by **frank** » 15 Jul 2010 20:40

4635 and RMA MOD board ..!?

RMA MODB is for common hardware.
4635 is for crystal hardware.
Where in the hell do you have a CS with a 4635 voicemail..!?

ccube · Post by **ccube** » 16 Jul 2010 00:10

Hi Frank,

Maybe the installation is a Crystal Hardware with Appliance Server as its CPU.

Post by **frank** » 16 Jul 2010 00:26

Never mind.
So your only solution is to use a MOXA box. This will let you telnet from the PBX into the 4635.

murraya · Post by **murraya** » 16 Jul 2010 06:51

It is possible, I have done it but my site was spacial redundancy so I used exb port to connect to voicemail. you will just need to play around with pinouts and it works.

beirut · Post by **beirut** » 17 Jul 2010 10:50

I know the best solution is to use MOXA, but sometime sales people knows nothing about the system and they sell anything to customer..
anyway I have an appliance server with crystal hardware. and wanna use MOD and RMA to remote connection.
If use EXB , I think I wont be able to use a remote connexion to z CPU.
Murray how managed to do this?
thx

murraya · Post by **murraya** » 18 Jul 2010 23:47

Hi, the config for port settings is.....

/Menu/Management/Devices

[1] SyA - CPU A
[2] SyB - Not used
[3] ExA - Console
[4] ExB - Modem
[5] ExC - Voicemail
[6] Debug
[7] All

Your choice: 5

/Menu/Management/Devices/ExC

[1] Interface
[2] Protocol
[3] Display on the fly
[4] Timout inactivity
[5] All

Your choice: 5

/Menu/Management/Devices/ExC/Interface/Setup

[1] Label : Voicemail
[2] Speed : 9600 Bauds
[3] Word size : 8 Bits
[4] Parity : No Parity
[5] Stop bit : 1 Stop Bit
[6] Flow control: XON/XOFF
[7] All

Your choice:

Hope that helps. configure a 3 wire cable only. i.e. TX,RX and GND.