SIP authentication - Password lengh OXE

[gfmtrade]

Thank you for all CCUBE we have to make some firewall config to test this Skype solution and we will see.
But first just to be sure configuring the public sip trunk well in oxe, we set up a connection to one of our sip trunk provider.
And of course we have problem.
I am really expert of OXO and I know how to do it but in oxe I need help.
We have a range of DDI numbers (hungarian local number from 3619991970 to 3619991971).
So oxe's two user should get it.
Of course we have a global authentication need to send e.g. 200sec.
The auth. user is : 3619991970 and the password is : 123456
OK
In case of using OXO after the authentication, we just configure the Public Numbering Plan (and ARS table) to route the external numbers to the right extension.
But in OXE just the first number work (xxxxxx1970) with one ext.gateway.
If we configure an other ext.gateway with the number xxxxxx1971 than it is come in.
Is it OK, it should work like this? If we have a externel direct number range from 100-199 then we need to configure 100 external gateway?
Can you help me or do I make an other post?
Best Regards
Attila

[ccube]

Hi Attila,

It would be best to make another post regarding this or check out the board for same issue you encounter.

[gfmtrade]

Ok, thank you very much again your help.
Best Regards

[OXE_4400]

OmniPCX Enterprise R10.1 SIP enhancements:
SIP trunking protocol adaptability
Authentication password length extension
The authentication digest can be up to 20 digits (instead of 10)