problem with AP85 TX mesh node

[wael]

dear all

I have two AP85 TX outdoor access points
I configured one of them to be Mesh portal
the other one I configured to be mesh node
the mesho portal is provisened by the controller and can be configured as reqired

the problem is with the mesh node AP: I configured the this AP to take its IP address from DHCP, with rols as mesh node then the configuration is saved and AP is rebooted. I can not reach this mesh node in ant way, the wireless controller is showing it to be down all the time.
any help please ?

[silvio]

have you tested it with static ip at the ap85 (mesh point)?
where is the dhcp for the mesh point: at the remote lan-port or at the oaw-side?
regards
Silvio

[it2000z]

Just configure the country in domain country profile to be france.

the problem is some channel no allowed fro LB country