Install vSROS with QENU on GNS3 1.1 Version

[ntobita]

Hi Folks,

I figured out how to save the configuration.

After the ADMIN SAVE on SROS:
1- go to the QEMU console of your vm,
2- in View menu select VC1,
3- verify if you have a snapshot of your disk with INFO SNAPSHOTS command,
4- if you have any snapshot is better delete all of them with DELVM command, like DELVM # (# is the snapshot file number),
5- so, with no more snapshots, do a SAVEVM 1 command, always use 1 to have just one snapshot file,
6- after this I did a Save Project just to be safe.

You can now close the GNS3 application and your configurations will be saved for next time.

Regards.

[zarkuc]

Hi, ntobita

Did you solve this problem ?

[ntobita]

Yes, doing the procedure as I said before. Regards.

[mostager]

hi notobita,

how can I get access to the qemu console ? If you mean the one who automatically open when I start the VSROS it's stuck in boot .

[chaplinis]

Hi, Drow, I did exacly what you said to do and the routers still not save the configuration. this is what I did

A:SROS-2# admin save cf3:\configR2.cfg
Writing configuration to cf3:\configR2.cfg
Saving configuration ... OK
Completed.
A:SROS-2# bof
A:SROS-2>bof# primary-config cf3:\configR2.cfg
A:SROS-2>bof# save
Writing BOF to cf3:/bof.cfg ... OK
Completed.
A:SROS-2>bof# exit all
A:SROS-2# admin save cf3:\configR2.cfg
Writing configuration to cf3:\configR2.cfg
Saving configuration ... OK
Completed.
A:SROS-2# show bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image cf3:\timos\both.tim
primary-config cf3:\configR2.cfg
autonegotiate
duplex full
speed 100
wait 3
persist off
no li-local-save
no li-separate
console-speed 115200
===============================================================================
A:SROS-2#

I dont knwo if Im missing something thank you again for the help....

[chaplinis]

ntobita » 20 Dec 2014, 18:12

Hi Folks,

I figured out how to save the configuration.

After the ADMIN SAVE on SROS:
1- go to the QEMU console of your vm,
2- in View menu select VC1,
3- verify if you have a snapshot of your disk with INFO SNAPSHOTS command,
4- if you have any snapshot is better delete all of them with DELVM command, like DELVM # (# is the snapshot file number),
5- so, with no more snapshots, do a SAVEVM 1 command, always use 1 to have just one snapshot file,
6- after this I did a Save Project just to be safe.

You can now close the GNS3 application and your configurations will be saved for next time.

Regards.

Hello ntobita, I did what you told me but I can not type on the QEMU console any command, am I missing any step before that?


thank you

[aman]

Hi Guys,
where to buy licensed Virtual TiMOS for GNS3? ALU don't even bother replying for the request to buy Virtual TiMOS firmware license.
Cheers,
Aman

[atamgole]

After admin save, suspend routers and save the project.
This brings back previous config when we restart the project.
For me it is working this way.