does our OXE system support those Interfaces?

[zidanski]

Hi,

i got request form my customer for designing IP telephony system with the following external interfaces:

1- PAGA system: interface to PAGA system 2 wires 600 ohm balanced with DTMF, if our OXE support that how can i find proper ACTIS configuration for.

2- Trunk UHF radio system: E1 PRI interface to VHF/UHF radio system, electrical interface will be 120 ohm, 4 wires, balanced with DTMF, is it supported or not and how can i configure the electrical interface specs on ACTIS

3- call logging: SMDR (station message detail recording) accessed via Ethernet, is it OV 8770?

4- GTP interface: the PBX shall interconnected with another telephony system located at GTP designed and supplied by EPC-1

5- E1 digital voice recording interface, how could find its ACTIS configuration.

6- E1 plant radio interface, is it the same as point no2 above, if not how to find its ACTIS config?

appreciate for fast reply.

[vad]

1 - I think yes but not clear - you need FXO, or FXS, or 2-wire E&M (analogue user, analogue trunk - NDDI or E&M)
2 - usually this is just public digital interface (NPRAE f.e.)
3 - may be (or customer already have OV and you need only licences in PBX)
4 - not clear. I think - this is just site name (GTP - f.e. gas treatment plant) but not interface type.
5 - UCC/XML WS/CTI, CSTA/CTI - Voice recording
6 - may be, but not clear (PRI or another type - R2 f.e.)