Call Forwarding not working

[thanzeel]

I have tried Changing to ISDN all country. But it's not working. This was the only trunk type the calls were working. But forwarding is not working

[vad]

With ABC-F type - OXE send information about forward and CUCM shall call forward destination.
With ISDN all countries - OXE will call forward destination.

But in any case - for ABC-F type:
- PABX address in DPNSS was created?
- System/ other system/ ext. signaling param - joining variant gf of diversion was managed "yes"?

After changing to ISDN all countries - may be you need to use command "killall sipmotor"?

[sadim]

Hi,
Cisco is ignoring 302 Moved Temporarily.
Is Redirect by Application enabled on Cisco SIP profile ?

[thanzeel]

Dear Sadim,

It is enabled.. They are also checking from their end on the issue

[rusi_costa]

Hey thazeel,
Use ISDN qsig if you have both systems in one place. You will have many issues not only forwarding. You can not make 3 party confernce between 2 cisco and alcatel. (One way speech path).
But sip idsn all countries will work. Again you will have dtmf issue accesing alcatel vm.

If you use abc-f, then you will not see cisco phone caller name.

Good luck....

Sent from my GT-N7105 using Tapatalk

[rusintha]

Hey thazeel,
Use ISDN qsig if you have both systems in one place. You will have many issues not only forwarding. You can not make 3 party confernce between 2 cisco and alcatel. (One way speech path).
But sip idsn all countries will work. Again you will have dtmf issue accesing alcatel vm.

If you use abc-f, then you will not see cisco phone caller name.

Good luck....

Cheers
Melan

Sent from my GT-N7105 using Tapatalk

[thanzeel]

Hi all,

The issue got resolved. Cisco Team added SIP Route pattern with the PABX IP and now the calls are going through if Alcatel extension is forwarded to another Alcatel extension.

Thanks everyone for their wonderful feedback.