Fuse on UA32

inticon · Post by **inticon** » 13 Dec 2004 23:38

Ummm *Nick looks confused*

I will try to push it in further when I get home. I thought CPU light was supposed to be fixed and blink when working? The CPU light is fixed on everything else?! (Inlcuding Z24, NDDI, Even CPU3)

Am I wrong or is the whole system dead?

Nick

inticon · Post by **inticon** » 14 Dec 2004 03:44

Ok - That IP was no go. I have also tried hunting down the previous owners but they seem to have vanished.

Also - UA's were pushed all the way in.

goldy · Post by **goldy** » 14 Dec 2004 07:12

ok, you probably need to connect a serial cable to it, if the board is not configured it will not come up at all. There is probably a CBRMA connection box, if so, coneect to A0. If you get a login prompt we are almost there,

who was the previous maintainer?

what customer is it, i may know the passswds for access, if not, get a login & we can work around it

Post by **frank** » 14 Dec 2004 11:34

Well... Here is the thing.. You told me you don't have a RMA box.. So how would you telnet the box ?

goldy · Post by **goldy** » 14 Dec 2004 17:52

hmmm, good point Frank.

initcon, is there an orange light on the cpu for the ethernet link?

Post by **frank** » 15 Dec 2004 14:41

Inticon :

Can you take a pic of your cabinet ?
I need a pic of the front, the back (doors open of course) and the top.
Do you have a rectifier ?

Thank you

Dave_DUP · Post by **Dave_DUP** » 12 May 2005 23:09

I have a note in my books on the default IP addresses:
Release 5.0 and below = 10.253.253.1
Release 5.1 and above = 155.132.1.1

NYCbrit · Post by **NYCbrit** » 25 Jun 2005 13:55

depending on how old the software is....it used to be 191.254.1.2 before R2 then just after became 10.253.1.1.

Alcatel Unleashed

Fuse on UA32

Oh My

Reply

Default IP's

Try this...