Alcatel Unleashed

Hi Folks,

I figured out how to save the configuration.

After the ADMIN SAVE on SROS:
1- go to the QEMU console of your vm,
2- in View menu select VC1,
3- verify if you have a snapshot of your disk with INFO SNAPSHOTS command,
4- if you have any snapshot is better delete all of them with DELVM command, like DELVM # (# is the snapshot file number),
5- so, with no more snapshots, do a SAVEVM 1 command, always use 1 to have just one snapshot file,
6- after this I did a Save Project just to be safe.

You can now close the GNS3 application and your configurations will be saved for next time.

Regards.

Hi, ntobita

Did you solve this problem ?

Yes, doing the procedure as I said before. Regards.

hi notobita,

how can I get access to the qemu console ? If you mean the one who automatically open when I start the VSROS it's stuck in boot .

Hi, Drow, I did exacly what you said to do and the routers still not save the configuration. this is what I did

A:SROS-2# admin save cf3:\configR2.cfg
Writing configuration to cf3:\configR2.cfg
Saving configuration ... OK
Completed.
A:SROS-2# bof
A:SROS-2>bof# primary-config cf3:\configR2.cfg
A:SROS-2>bof# save
Writing BOF to cf3:/bof.cfg ... OK
Completed.
A:SROS-2>bof# exit all
A:SROS-2# admin save cf3:\configR2.cfg
Writing configuration to cf3:\configR2.cfg
Saving configuration ... OK
Completed.
A:SROS-2# show bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image cf3:\timos\both.tim
primary-config cf3:\configR2.cfg
autonegotiate
duplex full
speed 100
wait 3
persist off
no li-local-save
no li-separate
console-speed 115200
===============================================================================
A:SROS-2#

I dont knwo if Im missing something thank you again for the help....

ntobita » 20 Dec 2014, 18:12

Hi Folks,

I figured out how to save the configuration.

After the ADMIN SAVE on SROS:
1- go to the QEMU console of your vm,
2- in View menu select VC1,
3- verify if you have a snapshot of your disk with INFO SNAPSHOTS command,
4- if you have any snapshot is better delete all of them with DELVM command, like DELVM # (# is the snapshot file number),
5- so, with no more snapshots, do a SAVEVM 1 command, always use 1 to have just one snapshot file,
6- after this I did a Save Project just to be safe.

You can now close the GNS3 application and your configurations will be saved for next time.

Regards.

Hello ntobita, I did what you told me but I can not type on the QEMU console any command, am I missing any step before that?


thank you

Hi Guys,
where to buy licensed Virtual TiMOS for GNS3? ALU don't even bother replying for the request to buy Virtual TiMOS firmware license.
Cheers,
Aman

After admin save, suspend routers and save the project.
This brings back previous config when we restart the project.
For me it is working this way.