Page 1 of 1
Trunk Lines on T2 and NDDI not working
Posted: 19 Jan 2007 09:46
by Donkilla7
Am at a site with A4400 and all my trunk lines are not working. What might be the problem. I had a hard disk crash and replaced it, loaded R 3.0
Posted: 19 Jan 2007 14:50
by cavagnaro
Check the board, unplug replug, try another board, try same board on other slot. Check line voltages.
Posted: 19 Jan 2007 14:51
by frank
do a trkstat cr cp and see if you have a CONNECT2 state.
If not, try to plug a loopback and see the status of the channels.
Trunk Lines on T2 and NDDI not working
Posted: 22 Jan 2007 02:43
by Donkilla7
Thanks. Just didn't want to believe that 5 NDDI boards were faulty. The problem was from the service provider. We were lucky that the PRA is by a fiber link. Had to rplace all the NDDI boards.