Page 1 of 1
Incompatible hardware for alcatel 8&9 series TDM set
Posted: 01 Jun 2010 03:04
by ybelal
Hi
When i try to create an extension with 4019/4029 set type in oxe rel7.1 in UA 32 board , if the address is 255,255,255 then it's ok but whenever i put equipment address then i get an error like below:
"Incompatible hardware for alcatel 8&9 series TDM set".
Any solution/help please.
Thank you.
Posted: 01 Jun 2010 03:15
by vad
Show config all. May be some problem - f.e. with 40x9 in remote shelf behind RT2 (INT1, INT2) or with INTOF if IO2 board absent.
Posted: 01 Jun 2010 04:06
by ybelal
It's in a remote shelf behind RT2. What we should do now please.
Posted: 01 Jun 2010 04:14
by vad
Use old sets (f.e. use new sets in shelf 0 and old type sets - 4010/ 4020/4035 - use in remote shelf), change RT2 to INTOF or INTIP.
Posted: 01 Jun 2010 04:21
by ybelal
If we change TR2 to PRA2, will it work?may be no option like that.PRA for inter node type link only. No way by changing any configuration in the system or inserting any board in main node or in remote shelf?
Posted: 01 Jun 2010 04:28
by vad
No. You need inter-ACT connection - RT2, INTOF, INTIP. Was system where people use INTIP for signaling (without VoIP and PRA2 for calls). But in this case you cannot dial internal number - you need to dial prefix+number.
If you cannot use INTOF - f.e. if used SDH/MUX 2 mbits equipment - you need 3d generation sets - 4004/4010/4020/4035.
Posted: 03 Jun 2010 10:49
by OXE_4400
ybelal wrote:Hi
"Incompatible hardware for alcatel 8&9 series TDM set".
Thank you.
9 series phones are incompatible with RT2 link. No way.