picture quality on multicast routing

[alcatel_user]

dear all,

I've picture quality issues in multicast routing. I've done configuration between two 6850 switches and running well, but there was bad picture in the client. I used vlc media player to test this multicast.
is there any missing configuration?
and here's my configuration :

vlan 11 enable name "pim_server"
vlan 11 port default 1/24
vlan 101 enable name "VLAN 101"
vlan 101 port default 1/1
! VLAN SL:
! IP :
ip service all
ip interface "ospf_link1" address 10.1.1.1 mask 255.255.255.252 vlan 101 ifindex 2
ip interface "pim_server" address 192.168.11.1 mask 255.255.255.0 vlan 11 ifindex 8
! IPX :
! IPMS :
ip multicast status enable
! AAA :
aaa authentication ssh "local"
! PARTM :
! AVLAN :
! 802.1x :
! QOS :
! Policy manager :
! Session manager :
session prompt default "Switch 1>"
! SNMP :
snmp security no security
snmp community map "public" user "snmpuser" on
snmp station 172.16.10.222 162 v2 enable
! RIP :
! OSPF :
ip load ospf
ip ospf area 0.0.0.0
ip ospf area 0.0.0.3
ip ospf interface "ospf_link1"
ip ospf interface "ospf_link1" area 0.0.0.0
ip ospf interface "ospf_link1" auth-type simple
ip ospf interface "ospf_link1" encrypt-key 51d1b8c52705e922461cdba297552eb8
ip ospf interface "ospf_link1" status enable
ip ospf interface "pim_server"
ip ospf interface "pim_server" area 0.0.0.3
ip ospf interface "pim_server" status enable
ip ospf status enable
! BFD-STD :
! ISIS :
! IPv6 :
! IPSec :
! IP multicast :
ip load pim
ip pim interface "ospf_link1"
ip pim interface "pim"
ip pim interface "pim_server"
ip pim cbsr 192.168.11.1
ip pim candidate-rp 192.168.11.1 224.0.0.0/4
ip pim static-rp 224.0.0.0/4 192.168.11.1
ip pim sparse status enable
ip pim dense status disable
ipv6 pim sparse status disable
ipv6 pim dense status disable
ip router router-id 100.100.100.1
! RIPng :
! OSPF3 :
! BGP :
! Health monitor :
! Interface :
! Udld :
! Netsec :
! Port Mapping :
! Link Aggregate :
! VLAN AGG:
! 802.1Q :
! Spanning tree :
bridge mode 1x1
! Bridging :
! Bridging :
! Port mirroring :
! UDP Relay :
! Server load balance :
! System service :
swlog console level info
! SSH :
! VRRP :
! Web :
! AMAP :
! LLDP :
! Lan Power :
! NTP :
! RDP :
! VLAN STACKING:
! Ethernet-OAM :
! EFM-OAM :
! ERP :

[cedric1]

hi

did you try client server on the same switch with only multicast switching

so to see if it is a pim issue or not

Cedric

[alcatel_user]

hi all,

i think this is nothing wrong with the configuration. and it's pure of my mistake, after i did with multicast switching in one switch and played with another movie format it's quality is fine.
then i did with multicast routing between two switches via ospf and played movie with format (.avi) it show good quality..
thanks for any comment post in my thread

case closed
--------------eof--------------