Page 1 of 1
4635 acess using RMA and MOD boards
Posted: 14 Jul 2010 19:55
by beirut
Anybody knows if is it possible to configure the minicom or 4635 V24 acess when using the RMA MOD board.
Posted: 15 Jul 2010 20:40
by frank
4635 and RMA MOD board ..!?
RMA MODB is for common hardware.
4635 is for crystal hardware.
Where in the hell do you have a CS with a 4635 voicemail..!?
Posted: 16 Jul 2010 00:10
by ccube
Hi Frank,
Maybe the installation is a Crystal Hardware with Appliance Server as its CPU.
Posted: 16 Jul 2010 00:26
by frank
Never mind.
So your only solution is to use a MOXA box. This will let you telnet from the PBX into the 4635.
Posted: 16 Jul 2010 06:51
by murraya
It is possible, I have done it but my site was spacial redundancy so I used exb port to connect to voicemail. you will just need to play around with pinouts and it works.
Posted: 17 Jul 2010 10:50
by beirut
I know the best solution is to use MOXA, but sometime sales people knows nothing about the system and they sell anything to customer..
anyway I have an appliance server with crystal hardware. and wanna use MOD and RMA to remote connection.
If use EXB , I think I wont be able to use a remote connexion to z CPU.
Murray how managed to do this?
thx
Posted: 18 Jul 2010 23:47
by murraya
Hi, the config for port settings is.....
/Menu/Management/Devices
[1] SyA - CPU A
[2] SyB - Not used
[3] ExA - Console
[4] ExB - Modem
[5] ExC - Voicemail
[6] Debug
[7] All
Your choice: 5
/Menu/Management/Devices/ExC
[1] Interface
[2] Protocol
[3] Display on the fly
[4] Timout inactivity
[5] All
Your choice: 5
/Menu/Management/Devices/ExC/Interface/Setup
[1] Label : Voicemail
[2] Speed : 9600 Bauds
[3] Word size : 8 Bits
[4] Parity : No Parity
[5] Stop bit : 1 Stop Bit
[6] Flow control: XON/XOFF
[7] All
Your choice:
Hope that helps. configure a 3 wire cable only. i.e. TX,RX and GND.