Alcatel Unleashed

Hi guys.

I need to change a voice guide for a new dynamic guide, for Common Hardware I maked it using AAS and it function ok, I did the same for the Crystal Hardware, but don´t let me make the assignmet of the guide number to the USCVG card, where actually is configured the voices guides.

My question is:

For USCVG card or other Crystal Hardware, there are any specific task to upload this guides?

Thanks a lot,


Schelbin Erik

Hi Erik,

You need a GPA/GPA2 card to configure dynamics voice guide on Crystal Hardware. If you want to update a voice guide stored on a USCVG bord you need to program the flash card directly with a laptop with a pcmcia port.

Regards,


Turlupin

Thanks Turlupin.

Then, I need to make with AAS a static voice guide and mark as the number of the guide that I need to put in service and record it into the flash memory that is actually in service in the USCVG?

Can you, or another, give some steps to upload my new voice guide to the USCVG pleae. What must I do into MGR to put in service the guide that I have been record it to the flash card?


Thanks to all.


Schelbin Erik

Run AAS, prepare project, compile project for flash card, put SUVG flash-card to notebook PCMCIA slot and write. But notebook PCMCIA slot not work with some cards (from my experience)