Alcatel Unleashed

Hi all, I have some problem here...

Why on CS-2 board can't be start up again after power failure on OXE. I can solve this, with unplugged CS-2 board and unplugged SATA-hard drive then put it back. But it become a frustrating problem in the unstable condition of electricity on site. Is there another way how to solve this problem or if there anyone else who have some problem with me, would you like to share with us?

Which SW version, patch You are using? Check for new patch. It can be some HW problem.

R9.0-h1.301-34 and also on R9.1-i160516c

Add batteries to your shelf. Make a mao and OPS backup outside the CS-2 HDD via ftp