Page 1 of 1
Speed mode intipb
Posted: 12 Aug 2010 03:37
by dryhouse
Hi Guys,
I need your help.I have this incident in my system:
12/08/10 08:57:51 000001M|001/20/-/---|=2:4408=INT-IP Ethernet error code 4 (status 1 0 0x0a4 0x00 0x00)
How can i configure speed mode parameters in this coupler (INTIPB)?
Gracias.
Posted: 12 Aug 2010 05:04
by murraya
Hi, connect to the intipb console port and enter in config mode. you can set QoS, Vlan, speed, duplex etc...
Posted: 12 Aug 2010 05:19
by dryhouse
How can i enter in config mode? I´ve never do it before...
Gracias brother
Posted: 12 Aug 2010 15:39
by murraya
HI, when the card boots follow the below.......
When the message Hit ENTER key to suspend coupler boot processis displayed, press Enter to display the main menu:
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––
IP configuration Menu
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Available commands :
– view : display current IP configuration
– chmode : change IP Configuration Mode (Static/dynamic)
– chip : change Static IP Parameters
- chqual : Change default quality Parameters
– save : saved modified configuration
– reset : reset coupler
Use? or ? <cmd> to get help on Command
Config:
Enter chmode, then 1 to change the initialization mode to Static mode.
Enter chip and configure the following IP parameters:
The INT-IP B board IP address,
The IP subnetwork mask,
The router IP address,
The TFTP server 1 IP address,
The TFTP server 2 IP address.
Enter save to save the parameters.
Posted: 15 Aug 2010 05:27
by mujib.alu
Hi,
It's very clear on Docs......System Documentation/System Seveices/Crystal Harware media gateway/Follow the INTIPB static config.....
try..!!
Posted: 16 Aug 2010 03:35
by dryhouse
How can i do it without reboot? in chview command can i see it?
Gracias.