Alcatel Unleashed

How to configure OXE to OXO SIP trunk?

ray_III wrote:Please how to configure OXE to OXO SIP trunk

Like normal SIP trunking. See both systems documentation.

And check many many posts about this

Hi

Let me do some questions about this topic too.
I'm trying to do the same, I think.
The scenario is:
OXO with analog and UA sets, IP trunk, there's no PCM or ISDN trunks.
OXE with SIP trunks, its extensions and one ISDN 30 channels trunk.

I want the OXO's extensions make their external calls through the ISDN trunk on OXE.
With OXO ok, I have set ARS table to send a number to the @IP of the OXE.
But in OXE, what is the numbering table that receives the number sent by OXO? I have set something at DDI numbering translator, am I right?
The extensions calls between OXO/OXE are right.

Thanks.

enio.eltz wrote:Hi

Let me do some questions about this topic too.
I'm trying to do the same, I think.
The scenario is:
OXO with analog and UA sets, IP trunk, there's no PCM or ISDN trunks.
OXE with SIP trunks, its extensions and one ISDN 30 channels trunk.

I want the OXO's extensions make their external calls through the ISDN trunk on OXE.
With OXO ok, I have set ARS table to send a number to the @IP of the OXE.
But in OXE, what is the numbering table that receives the number sent by OXO? I have set something at DDI numbering translator, am I right?
The extensions calls between OXO/OXE are right.

Thanks.

Manage DDI translation in OXO. You can set different DDI trnslation using one private route to OXE for user to user dialling and a public route for transit through OXE.

Hi tot3nkopf

Yes, I am doing this way.

For example at OXO ARS:
priv 15 00-99 15 7 and all IP settings. This is the rule to call extensions from oxo to oxe. It is working fine.
publ 81181862 no intervals 081181862 7 and all IP settings. This is a rule to make an external call through oxe.

For example at OXE DDI number translator rules:
DDI identifier:34
First external number: 1500
First internal number: 500
Range size: 100
To receive the number from oxo. It is working fine.

DDI identifier:34
First external number: 0
First internal number: 0
Range size: 1
To receive the number of the external number from oxo.
This is the setting I am not sure I am doing right.
At the oxe prefix plan there is 0-ARS prof. trunk group seiz. with overlap.

Thanks.

OXE NPD should have calling DID -1 and called DID -1 (no DID table used)

i have to repeat myself: translation is made on OXO, not on OXE. OXE just passes the numbering to the public TG.

Hi Tot

This must be my mistake. I am doing now a test in my lab. I am going to change NPD calling DID to -1. I post here the results.

Thanks a lot.

Hi Tot

Thank you very much for your fast answer. It worked very fine. That was my mistake. I mustn't translate what oxe receives from oxo. When oxe receives, for example, 0 + number, prefix plan gets them an does the job.