Alcatel Unleashed

Hi,

Im newbies to alcatel. Having a problem to understand and locate port 0/1.
When i do arp lookup, there's IP and mac on interface 0/1, but I unable to locate interface 0/1.
What command should I use and why it is not listed in the interfaces?

myomni6580-> show arp 10.128.0.12

Total 214 arp entries
Flags (P=Proxy, A=Authentication, V=VRRP)

IP Addr Hardware Addr Type Flags Port Interface Name
-----------------+-------------------+----------+-------+--------+-----------+----------
10.128.0.12 00:09:72:5e:76:ea DYNAMIC 0/1 vlan 304

=========================================
myomni6580-> show interfaces status
DETECTED CONFIGURED
Slot/ AutoNego Speed Duplex Hybrid Speed Duplex Hybrid Trap
Port (Mbps) Type (Mbps) Mode LinkUpDown
-----+--------+------+------+------+--------+------+------+------
1/1 Enable 1000 Full NA Auto Auto NA Enable
1/2 Enable 1000 Full NA Auto Auto NA Enable
1/3 Enable - - - 1000 Full NA -
1/4 Enable - - - 1000 Full NA -
1/5 Enable - - - 1000 Full NA -
1/6 Enable - - - 1000 Full NA -
1/7 Enable - - - 1000 Full NA -
1/8 Enable - - - 1000 Full NA -
1/9 Enable - - - 1000 Full NA -
1/10 Enable - - - 1000 Full NA -
1/11 Enable - - - 1000 Full NA -
1/12 Enable - - - 1000 Full NA -
1/13 Enable - - - 1000 Full NA -
1/14 Enable - - - 1000 Full NA -
1/15 Enable - - - 1000 Full NA -
1/16 Enable - - - 1000 Full NA -
1/17 Enable - - - 1000 Full NA -
1/18 Enable - - - 1000 Full NA -
1/19 Enable - - - 1000 Full NA -
1/20 Enable - - - 1000 Full NA -
1/21 Enable - - - 1000 Full NA -
1/22 Enable - - - 1000 Full NA -
1/23 Enable - - - 1000 Full PF Enable
1/23 Enable - - - 1000 Full PF Enable
1/24 Enable 1000 Full C Auto Auto PF Enable
1/24 Enable 1000 Full C Auto Auto PF Enable
1/25 Enable 1000 Full C Auto Auto PF Enable
1/26 Enable 1000 Full C Auto Auto PF Enable

FF - ForcedFiber PF - PreferredFiber F - Fiber
FC - ForcedCopper PC - PreferredCopper C - Copper

Hi,
there is a LAG port.

Thanks a lot, now I found it.

I see the description for neighbor switch but not the IP address.
Now I manage to find the IP address of the remote switch using show amap command.

Thanks again.